TECHNICAL DATA
Flow rate minimum and maximum: from 0,3 m3/h to 36,67 l/min
Head up to: 32,5 m
Type of pumped liquid: clean, free from solid or abrasive substances, non-viscous, non-aggressive, non-crystallized and chemically neutral
Liquid temperature range:
from +0°C to +35°C for domestic use
from -10°C to +50°C for other use
Maximum ambient temperature: + 40°C
Maximum operating pressure: 6 bar (600 kPa)
Motor protection class: IP 44
Motor insulation class: F
Impeller material: brass
Single phase power input: 230 V 50 Hz
Nominal power: 0.37kW
Possible type of installation: fixed, horizontal position
Max power: 0.53kW

Peripheral centrifugal pumps to be used in domestic and residential environments designed for pressurization, rainwater re-use or gardening and irrigation.


CONSTRUCTION FEATURES OF THE PUMP
KPF has the threaded inlet on the front. Carbon-ceramic mechanical seal. Brass impeller.

CONSTRUCTION FEATURES OF THE MOTOR
Air-cooled asynchronous motor. Motor shaft in AISI 416 stainless steel.
Motor circuit breaker and permanent capacitor included as standard in the single-phase version.
Protection by the user for the three-phase versions.

View on DNA

KPS KPF – TECHNICAL SHEET

Replacement Parts

Plumbing and Pipe Connections

This pump has standard 25mm (1 inch) connectors.

Although 25mm is a fairly common size, depending on your inlet, you might need to upsize or downsize your pipe. Most common sizes after 25mm are either 20/22mm or 32mm. If needing to change, we suggest using a compression reducing male adapter or else a compression reducing male elbow.

We also recommend installing a ball valve on the inlet before the pump.

Thread tape will most likely be needed when installing these fittings.

If a pressure control head is being installed as well, then the outlet size must also be verified.

Electrical Requirements

This pump works on 220V standard out the box. If you are installing the pump directly, you just need a cable with power. We strongly suggest installing a switch close to the pump though or else connecting a little wire to a plug where it can be inserted in a nearby power outlet socket.

Placing the pump

We recommend connecting this pump close to the tank or water source. We also recommend placing it with consideration of the noise.

Please note that this pump does not include a control head so if switched on, it will run at full capacity. A pump controller head is recommended for any domestic installations.